USB Full Speed to Parallel FIFO Interface with USB Charger Detection
FT240X - Full Speed USB to 8- bit FIFO
This USB2.0 Full Speed IC offers a compact bridge to 8 bit wide FIFO interfaces. The device is a FIFO, capable of operating up to 1 MByte/s, with low power consumption (8mA). The FT240X includes the complete FT-X series feature set and enables USB to be added into a system design quickly and easily over a 8 bit wide FIFO interface
Key Hardware Features
Entire USB protocol handled on the chip. No USB specific firmware programming required.
Fully integrated 2048 byte MTP Memory for storing device descriptors and CBUS I/O configuration.
Fully integrated clock generation with no external crystal required plus optional clock output selection enabling a glue-less interface to external MCU or FPGA.
Data transfer rates to 1 MByte/s
512 byte receive buffer and 512 byte transmit buffer utilizing buffer smoothing technology to allow for high data throughput.
FTDI's royalty-free Virtual Com Port (VCP) and Direct (D2XX) drivers eliminate the requirement for USB driver development in most cases.
Configurable CBUS I/O pins.
Transmit and receive LED drive signals.
Synchronous and asynchronous bit bang interface options with RD# and WR# strobes.
Battery Charger Detection. May be used by mobile devices to detect the presence of a charger on the USB port to enable higher current / faster charging of batteries.
Device supplied pre-programmed with unique USB serial number.
Supports bus powered, self powered and high-power bus powered USB configurations.
Integrated +3.3V level converter for USB I/O.
Device supplied pre-programmed with unique USB serial number.
Supports bus powered, self powered and high-power bus powered USB configurations.
Integrated +3.3V level converter for USB I/O.
True 3.3V CMOS drive output and TTL input.
(Will operate down to 1V8 with external pull-ups, also 5V tolerant )
Configurable I/O pin output drive strength.
Integrated power-on-reset circuit.
Low USB bandwidth consumption.
UHCI/OHCI/EHCI host controller compatible.
USB 2.0 Full Speed compatible.
Extended operating temperature range: -40°C to 85°C
Available in compact Pb-free 24 Pin SSOP and QFN-24 packages (both RoHS compliant).